How to Activate Matrice 200 Series V2 Aircraft

How to Activate Matrice 200 Series V2 Aircraft





Step 1
Connect mobile device (CrystalSky Monitor) to internet and connect to the remote controller.

Step 2
Turn on the remote controller and power on the aircraft

Step 3
Load DJI Pilot app and login with the DJI account. The activation page will pop-up. Authorize DJI to access your DJI device hardware information.

Step 4
Adjust parameters as desired. 

Step 5
Tap "activate" to finish the activation. You may now start your flight mission.



    • Related Articles

    • DJI M300 RTK Verification Standards

      M300RTK VIDEO VERIFICATION STANDARDS Before shooting the video, please pay attention to the instructions below. -  Show the aircraft, remote controller, and app in the same shot.  -  Please shoot the video in a safe, bright and outdoor area. -  ...

    • Phantom 4 RTK Network RTK Setup Guide

      1. Insert a WB37 Intelligent battery into the Phantom 4 RTK remote controller, turn on the remote controller by quickly press twice and then hold the power button. 2. Insert a Phantom 4 Intelligent Flight Battery into the Phantom 4 RTK aircraft and ...

    • Matrice 30 Series Training

    • AVSS Parachute User Manual

      Download the attachment below to view the AVSS Parachute user manual for the DJI M300. The user manual contains information about the parachute, safety instructions, installation, battery/charging, firmware, operating procedures, maintenance and ...

    • DJI Inspection Guidelines

      DJI Inspection Guidelines It is important to inspect your aircraft before, during and after each flight. To fly responsibility, you must make sure that your aircraft is in proper flying condition before taking off. You can ensure that your drone or ...