M300RTK VIDEO VERIFICATION STANDARDS
Before shooting the video, please pay attention to the instructions below.
- Show the aircraft, remote controller, and app in the same shot.
- Please shoot the video in a safe, bright and outdoor area.
- Please ensure the video is clear and focused.
- Please ensure the video is filmed in one take without interruption, and please do not edit the video.
When recording the verification video, please record the following content in order.
Verification Video Sample：s.dji.com/M300RTKEN
Step 1：Show the serial number
Capture the aircraft’s serial number. Please make sure the numbers are clearly visible and not altered.
*The serial number is located at the aircraft nose.
Step 2：Install gimbal
Install one or two gimbals onto the aircraft. You can choose from the Zenmuse H20, H20T, XT S, Z30, and XT2. If the aircraft is used with the downward dual gimbal connector, then mount cameras on both gimbal port 1 and 2.
Step 3：Power On
Power on the remote controller and the aircraft, and then launch DJI Pilot.
Step 4：Check the flight status
①Open “Aircraft Status” list, and slowly scroll down the list to the bottom, ensuring there is no error reported.
②Open HMS menu and ensure there is no red (warning state) or orange (caution state) notice under each module.
Step 5：Check the firmware version
Check the firmware version of the aircraft, ensuring it is updated to the latest version. Please go to DJI’s official website and check the latest firmware version in the release notice.
Step 6：Show the gimbal performance
After making sure the gimbal can complete self-inspection process, use the left toggle wheel on the remote controller to demonstrate that the gimbal’s tilt axis can be adjusted.
Step 7：Check the image transmission
①Go to the image transmission page and ensure the image transmission is normal.
②Capture a photo or video.
*There is no requirement for photo/video specifications, and you only need to ensure the photo/video can be taken normally.
Step 8：Start the motors
Push both sticks to the bottom inner or outer corners to start the motors. Toggle the throttle sticks to make sure the motor’s speed is controllable.
*Please make sure to keep the aircraft in safe distance and the aircraft does not take off.
Step 9：Stop the motors
Push both sticks to the bottom inner or outer corners to stop the motors.
Step 10：Check if RTK function is normal（Choose one of the tests below accordingly）
A：For the Matrice 300 RTK and Custom Network RTK
①Place Matrice 300 RTK in a safe and open environment.
②Power on remote controller and aircraft. Ensure the remote controller can connect to the internet normally.
③Launch DJI Pilot. Tap the satellite signal icon, and then choose Custom Network RTK as the RTK service type. Check network RTK state and aircraft RTK state and the RTK signal should be normal.
④Capture the blinking state of the aircraft status indicator.
B：For the Matrice 300 RTK with D-RTK 2 High-Precision GNSS Mobile Station for Matrice Series
①Place Matrice 300 RTK and D-RTK 2 High-Precision GNSS Mobile Station for Matrice Series in a safe and open environment.
②Power on remote controller, aircraft, and mobile station.
③Press and hold the operating mode button of the mobile station, switching it to Broadcast mode.
④Launch DJI Pilot. Tap satellite signal icon, choose D-RTK 2 Mobile Station as RTK service type, and then app will start to search for mobile stations. Connect the aircraft to the mobile station. Check the status of the D-RTK 2 mobile station and the RTK signal should be normal.
⑤Capture the blinking state of the aircraft status indicator.
Step 11：Power off
Power off the aircraft and the remote controller, and then stop recording.
Thank you for your cooperation. If you have any question, please contact us via DJI Support. Thank you!