Popular Articles
How To Use DJI D-RTK2 Base Station As GNSS Rover (Network)
Introduction The purpose of this document is to show our users how to connect to a custom network with the D-RTK 2 to acquire latitude, longitude, and height. What You Will Need D-RTK 2 on firmware v02.02.0014 or later. Phantom 4 Remote Controller ...
Static (.dat) To RINEX conversion tool by Stonex
This tool is used to convert the .dat (binary) file of the static data logged on the Stonex GNSS receiver to Rinex (ASCII) format. In case the user has already selected in the receiver’s WebUI to convert the static file from .dat to Rinex, this ...
How To Attach MicaSense RedEdge MX Into Payload Bay
REQUIRED PARTS Allen Screwdriver 2.5 mm Procedure For an easier application of the DF13 plugs, detach the cable from the mount. Attach the three DF13 connectors carefully to the camera. Take care that you only push at the plastic part to plug in the ...
LP12 Searchlight & Broadcasting System - User Manual
1. Introduction of LP12 CZI LP12 searchlight & broadcasting system is a two-in-one payload specially designed for the DJI M30. LP12 is with a streamlined aesthetic design concept. It challenges the limits of performance while maintaining artistic ...
Stonex S10 height measurements
Note that in Carlson Surv software, the antenna height can be recorded either as vertical or slant. The vertical ‘Vert’ height is measured vertically up until the ground to the bottom of the receiver, while the ‘Slant’ refers to the height measured ...