How to update APACHE Firmware via Webpage
Prerequisites:
- Boat（GD100）with batteries
- 5GHZ antenna
- PC with WIFI
Note: the new firmware should be compatible with the new software that come with the released firmware.
Steps:
1. Power on the boat and install 5GHZ antenna on the boat.
2. Connect the boat WIFI, logon the webpage: http://192.168.53.254/pc/login.html?v=4
Username: admin
Password: Admin1234
3. Click ‘Firmware’ ‘Firmware Update’ select the bin file to update GD100 host.
After click ’Confirm’ button , it is going to upload firmware to GD100 automatically. In the next few minutes,
you will hear a sound music and a long beep twice. After uploading interface disappeared, that mean update
firmware successfully.
4. Connect the boat WIFI again, logon the webpage: http://192.168.53.254/pc/login.html?v=4
5. Click ‘Firmware’ ‘Firmware Update’ select the Px4 file to update control firmware(integrated receiver).
After click ’Confirm’ button , it is going to upload firmware to receiver automatically. In the next few minutes,
you will hear a sound music and a long beep. After uploading interface disappeared, that mean update
firmware successfully.
6. Connect the boat to PC via the Wifi, logon the webpage :http://192.168.53.254/pc/login.html?v=4
7. Go to ‘Firmware’ ‘Firmware Information’ ,check the version of the firmware.
8. Connect the boat to PC via the Wifi
9. Connect the boat to Autoplanner via TCP mode.
10. Go to parameter interface
11. Write new parameters to the boat.
Related Articles
APACHE 3 User Guide (Network Bridge Version)
Introduction The APACHE 3 USV User Guide describes how to set up and use the CHC® APACHE 3 USV. In this manual, “the USV” refers to the APACHE 3 USV unless otherwise stated. Even if you have used other Unmanned Surface Vessel before, CHC recommends ...APACHE 3 User Guide (4G Version)
Introduction The APACHE 3 USV User Guide describes how to set up and use the CHC® APACHE 3 USV. In this manual, “the USV” refers to the APACHE 3 USV unless otherwise stated. Even if you have used other Unmanned Surface Vessel before, CHC recommends ...DJI-M300 RTK - How to update the firmware
Update Remote Controller Turn on the controller, make sure the controller is connected to the internet. Click on the firmware update notification to download all updates. Battery Station Activation Must be activated before use - Solid yellow ...LP12 Firmware Upgrade
Introduction In this article, you can find the instructions on how to upgrade the firmware for, new features about and the fix issues for the LP12. New Features ...Trinity F90: How To Update RC Transmitter Firmware
1. Connect the USB cable to the Mini USB port on the back of the transmitter and connect the transmitter to your computer, laptop or tablet. 2. The transmitter is switched on. 3. Select USB data connection. 4. The transmitter COCKPIT_C3 is now ...